Cooling System/Install Water Pump 6. Apply a coat of LOCTITE 518 Flexible Sealant to the gasket surfaces (A and B). Install a new gasket and pump cover. Tighten the four cover cap screws to 30 N·m (22 lb-ft). 7. If drain valve is removed, apply LOCTITE 592 Pipe Sealant to threads and tighten drain valve to 27 N·m (20 lb-ft). RG5851 -UN-13AUG91 8. Install new weep hole filters and a new O-ring on the pump housing pilot. RG,CTM42,G25,21-19-16AUG94 INSTALL ENGINE WATER PUMP 1. Apply a light coat of engine oil to water pump housing O-ring (A). Install pump into pilot bore in block making sure that pump drive gear properly meshes with camshaft gear. RG5850 -UN-13AUG91 2.
Install two water pump mounting cap screws and tighten to 27 N·m (20 lb-ft). 3. Install a new gasket (B) between water inlet manifold elbow and cylinder block. Install two 5/16 in. inlet manifold elbow cap screws and tighten to 27 N·m (20 lb-ft). RG,CTM42,G25,22-19-16AUG94 4. Install new O-ring (A) into bore of water outlet manifold. Lubricate O-ring with engine oil and install bypass pipe into water outlet manifold. 25 21 5. Install new O-ring (B) in water bypass fitting. Lubricate O-ring with engine oil and install fitting onto pump end of bypass pipe. RG5853 -UN-13AUG91 6. Apply LOCTITE 592 Pipe Sealant with TEFLON to fitting threads and screw fitting into water pump housing.
Tighten securely. 7. Install clamp (C) with “J” of clamp toward rear of engine on inside-upper injection pump drive gear cover cap screw. CTM42 (24MAR95) 25-21 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G25,23-19-16AUG94 160101 PN=240