Cooling System/Remove and Test Thermostats REMOVE AND TEST THERMOSTATS N CAUTION: Explosive release of fluids from pressurized cooling system can cause serious burns. Do not drain coolant until coolant temperature is below operating temperature. Always loosen cooling system filler cap, radiator cap, or drain cock slowly to relieve pressure. RG5279 -UN-14DEC88 1. Visually inspect the area around the water manifold for leaks. Partially drain coolant from the cooling system. 2. Remove thermostat cover (A). RG,CTM42,G25,24-19-29OCT92 3. Remove thermostats (A). Discard gasket (B). 4. Inspect thermostats for debris or damage, and test each thermostat using an approved thermostat testing procedure.
See INSPECT THERMOSTAT AND TEST THERMOSTAT OPENING TEMPERATURE in Group 105 for thermostat testing procedure. Thermostats should start to open within the range specified. RG5280 -UN-09DEC88 THERMOSTAT OPENING TEMPERATURE SPECIFICATIONS 82˚C (180˚F) Thermostat(s) . . . . . . . . . . . . . 80—84˚C (175—182˚F) 89˚C (192˚F) Thermostat(s) . . . . . . . . . . . . . 87—91˚C (188—195˚F) If either thermostat fails to open within this range, replace both thermostats. 25 22 RG,CTM42,G25,43-19-29OCT92 CTM42 (24MAR95) 25-22 6076 Diesel Engines—S.N. (500000— ) 160101 PN=241