John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Extending Turbocharger Life EXTENDING TURBOCHARGER LIFE Turbochargers are designed to last the life of the engine, but, because they operate at such high speeds (100,000 rpm or more); a moment’s carelessness can cause them to fail in seconds. The major causes of turbocharger failures are attributed to:

• Lack of lube oil (quick starts and hot shutdowns) • Oil contamination • Ingestion of foreign objects • Restricted oil drainage • Low oil level • Operation on excessive side slopes • Abnormally high exhaust temperatures S55,3005,E -19-06APR94 • Lack of Lube Oil Oil levels and pressure should always be closely monitored and all worn hoses and lines should be replaced. The turbocharger oil supply line should be checked frequently to make sure it is not kinked or bent and it should always be replaced with a line of equal size, length and strength. Oil not only lubricates the turbocharger’s spinning shaft and bearings, it also carries away heat.

When oil flow stops or is reduced, heat is immediately transferred from the hot turbine wheel to the bearings, which are also heating up because of the increased friction due to the lack of oil. This combination causes the turbocharger shaft temperature to increase rapidly. The easiest way to damage a turbocharger is through improper start-up and shutdown procedures. Always idle the engine for at least 30 seconds (no load) after start-up and before shutdown. Warming the engine up before applying a load allows oil pressure to build up and lines to fill with oil. If oil flow does not increase and the process continues, bearings will fail.

Once the bearings fail (which can happen in just seconds) seals, shaft, turbine and compressor wheels can also be damaged. 30 4 Idling the engine before shutdown allows the engine and turbocharger to cool. “Hot” shutdowns can cause the turbocharger to fail because after high-speed operation the turbocharger will continue to rotate long after the engine has been shut off and oil pressure has dropped to zero. This will cause heat to build up and possible bearing damage. It can also cause carbon and varnish deposits to form.

The principle causes of turbocharger bearing lubrication problems are low oil pressure, a bent, plugged or undersized oil lube supply line, plugged or restricted oil galleries in the turbocharger, or improper machine start-up and shutdown procedure. CTM42 (24MAR95) 30-4 6076 Diesel Engines—S.N. (500000— ) S55,3005,F -19-04JUN93 160101 PN=249