John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Extending Turbocharger Life • Oil Contamination Four good ways of avoiding oil contamination are: A second cause of turbocharger failures is contaminated oil. It can be caused by a worn or damaged oil filter or not changing the lube oil at recommended intervals. Expecting the oil filter to remove dirt, sand, metal chips, etc. from the oil before they reach the engine or turbocharger can be a costly mistake because contaminated oil may completely bypass the engine oil filter if the oil filter or oil cooler is clogged, if the filter element is improperly installed, or if the oil is thick during cold weather.

— Always inspect the engine thoroughly during major overhaul. Look especially for any sludge or debris left in lube oil galleries. — Change lube oil at recommended intervals. Analysis of oil samples at filter change periods can help identify potentially harmful contaminants in the oil. — Clean the area around the oil fill cap before adding oil. — Use a clean container when adding oil. S11,3005,MK -19-04JUN93 • Ingestion of Foreign Objects The result is erosion of compressor blades that can cause the delicately balanced wheel to wobble. The third cause of turbocharger damage is the ingestion of foreign objects.

Foreign objects or particles can be ingested and cause damage to the turbocharger on both compressor and turbine sides. This is easy to avoid. IMPORTANT: Whenever an internal engine failure (valve, valve seat, piston) occurs, a thorough inspection of the turbocharger MUST BE performed before returning engine to service. On the compressor side, foreign objects usually take the form of dust, sand, or shreds of air cleaner element that enter through improperly installed air cleaner elements. Leaky air inlet piping (loose clamps or torn rubber joints) or torn pleats in dry-type air cleaner elements also create problems.

S11,3005,ML -19-04JUN93 • Restricted Oil Drainage There are two primary reasons for restricted drainage. A blocked drain tube, due to either damage or a buildup of sludged oil or high crankcase pressure which can be due to restricted crankcase breather or excessive engine blowby. 30 5 A fourth cause of turbocharger damage is restricted lube oil drainage. The lubricating oil carries away heat generated by friction of the bearings and from the hot exhaust gases. If drainage back to the sump is impeded, the bearings will overheat with damage that will ultimately lead to failure. Periodically check both the turbocharger oil drain tube and engine breather tube for damage or restriction.

Correction of these conditions leads to longer turbocharger life. CTM42 (24MAR95) 30-5 6076 Diesel Engines—S.N. (500000— ) RG,CTM8,G30,R1 -19-04JUN93 160101 PN=250