John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Remove Turbocharger • Abnormally High Exhaust Temperatures Causes of restricted air flow can include damaged inlet piping, clogged air filters, excessive exhaust restriction, or operation at extreme altitudes. Overpowering generally is due to improper fuel delivery or injection timing. If overtemperature operation has been identified, an inspection of the air inlet and exhaust systems should be performed. Also, check the fuel delivery and timing. A fifth cause of turbocharger damage is abnormally high exhaust temperatures. Elevated exhaust temperatures cause coking of oil which can lead to bearing failure. Extreme over-temperature operation can case wheel burst.

There are two basic causes of over-temperature. The first is restricted air flow and the second is overpowering the engine. In either case the engine has more fuel than available air for proper combustion, this overfueled condition leads to elevated exhaust temperatures. RG,CTM8,G30,R2 -19-19AUG92 REMOVE TURBOCHARGER N CAUTION: After operating engine, allow exhaust system to cool before removal. NOTE: Your 6076 Engine is equipped with either AiResearch/Garrett, Holset, or Schwitzer turbochargers. Removal and installation procedures are the same for all turbochargers, but repair of AiResearch/Garrett and Schwitzer differ. Refer to the proper repair section when repairing turbocharger.

Repair parts are not available for Holset turbochargers; if defective, install a replacement. Thoroughly clean exterior of turbocharger and surrounding area to prevent entry of dirt into the air intake system during removal. IMPORTANT: When cleaning turbocharger, do not spray directly into compressor cover or turbine housing. If turbocharger inspection is required, do not clean exterior prior to removal. Doing so may wash away evidence of a potential failure mode. (See TURBOCHARGER SEVEN STEP INSPECTION, later in this group.) 30 6 RG,CTM42,G30,11-19-29OCT92 CTM42 (24MAR95) 30-6 6076 Diesel Engines—S.N. (500000— ) 160101 PN=251