John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Remove Turbocharger NOTE: 6076A shown, 6076T and H similar. 1. Remove exhaust elbow (A). Remove clamp and exhaust adapter (B). 2. Disconnect oil inlet line (C). Loosen oil return tube cap screws using JDG626 Special Socket Adapter with JDE80 and standard 9/16 12-point, 3/8 in. drive socket and remove oil return tube (D). Discard gasket. 3. Remove four turbocharger mounting cap screws with washers and lift turbocharger from exhaust manifold. Disengage turbocharger from intake manifold coupling (E). Discard turbocharger-to-coupling O-ring. RG5283 -UN-20DEC88 4.

Cap or plug all openings (exhaust and intake manifold related) and place turbocharger on a clean flat table for inspection. 5. Perform turbocharger seven-step inspection, as described later, if failure mode has not been determined. A—Exhaust Elbow B—Exhaust Adapter C—Oil Inlet Line D—Oil Return Tube E—Intake Manifold Coupling RG,CTM42,G30,12-19-29OCT92 30 7 CTM42 (24MAR95) 30-7 6076 Diesel Engines—S.N. (500000— ) 160101 PN=252