John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Turbocharger Failure Analysis TURBINE HOUSING OUTLET DEFECTS Problem Possible Cause Suggested Remedy Turbine Wheel Rub Bearing failure. Determine if engine and/or operator contributed to lack of lubrication, contaminated lubrication, excessive temperature, or debris generating engine failure in progress. Correct as required. Manufacturing defect. Correct as required (this group). Foreign Object Damage Internal engine failure. Inspect and repair engine as required. Objects left in intake system. Disassemble and inspect air intake system, (this group). Leaking air intake system. Correct as required, (this group).

Oil and/or Excessive Carbon Internal engine failure. Verified by oil in turbine housing. Correct as required. Turbine seal failure. Inspect for excessive heat from overfueling and/or restricted air intake. Prolonged periods of low RPM Verify with operator to run engine under load engine idling. or a higher RPM. (Operator’s Manual.) joints. Restricted oil drain line. Inspect and clear oil drain line as required. EXTERNAL CENTER HOUSING AND JOINT DEFECTS Leaks from Casting Defective casting. Replace turbocharger, (this group). Defective gasket. Verify that leaks are not occurring at gasket joints. Leaks from Joints Loose attaching screws. Tighten to specifications in CTM, (this group).

Defective gasket. Inspect and repair as required. INTERNAL CENTER HOUSING DEFECTS Excessive Carbon Build up Hot engine shut-down. Review proper operation with operator in Housing or on Shaft as shown in Operator’s manual. 30 9 Excessive operating Restricted air intake; temperature. Overfueling or Mistimed engine Restricted oil drain line. Inspect and clean oil drain lines as required. Operating engine at high Idle engine for a few minutes to allow oil to speeds and loads immediately reach bearings before applying heavy loads. after start-up. S11,3005,JG -19-28SEP94 CTM42 (24MAR95) 30-9 6076 Diesel Engines—S.N. (500000— ) 160101 PN=254