John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Remove, Inspect, and Install Intake Manifold REMOVE, INSPECT, AND INSTALL INTAKE MANIFOLD (6076T AND 6076H ENGINES) IMPORTANT: All intake manifold connections at the turbocharger and engine cylinder head must be tight to prevent loss of power resulting from lower manifold pressure. RG5860 -UN-13AUG91 Intake manifold hose and cap screw connections should be inspected periodically for tightness. Whenever a tune-up has been performed on the engine, or whenever it is suspected that the horsepower output might be low, the intake manifold pressure (turbocharger boost should be checked. (See Group 110.) NOTE:

On 6076 HRW 33, 34, and 35 Engines, the exhaust manifold must be removed before removing intake manifold. 1. On 6076T engines, loosen hose clamps (A) on lower air intake hose. 2. On 6076H engines, remove connections from compressor outlet and intake manifold. 3. Disconnect aneroid line, if equipped. 4. Disconnect ether starting aid pipe from manifold, if equipped. 5. Remove six manifold mounting cap screws and intake manifold. 6. Inspect the intake manifold for serviceability. Replace if it is cracked or otherwise damaged. 7. Inspect the machined mating surfaces of cylinder head and intake manifold. Clean, as required, by using a scraper and/or wire brush, and compressed air. 8.

To install intake manifold, reverse removal procedures and use new gaskets. 30 22 9. Make sure air intake hose is in good condition. Tighten hose clamps to 9—13 N·m (12—17 lb-ft) (146—203 lb-in.). 10. Tighten intake manifold attaching cap screws to 47 N·m (35 lb-ft). CTM42 (24MAR95) 30-22 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G30,40-19-14FEB95 160101 PN=267