John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Install Turbocharger NOTE: Coat coupling O-rings with liquid soap or grease as an aid during assembly. Install turbocharger oil drain tube on engine before mounting turbocharger. Guide studs may be used to position exhaust gasket during turbocharger installation. 3. Mount turbocharger on engine, making sure coupling (E) is properly seated over compressor housing and in intake manifold. 4. Apply PT569 NEVER-SEEZ Compound to all turbocharger mounting cap screws. Install cap screws and tighten to 24 N·m (18 lb-ft). On 6076T engines, tighten hose clamps on intake manifold and coupling hose to 9—13 N·m (12—17 lb-ft) (146—203 lb-in.). RG5283 -UN-20DEC88 NOTE:

Remove all caps or plugs from turbocharger openings. A—Exhaust Elbow 5. Using a new gasket, install oil drain tube (D). Tighten B—Exhaust Adapter cap screws securely using JDG626 Special Socket C—Oil Inlet Line Adapter with JDE80 and standard 9/16, 12-point, 3/8 in. D—Oil Drain Tube drive socket. Connect oil inlet line (C) and tighten to E—Coupling 26—34 N·m 19—25 lb-ft). 6. Install exhaust adapter (B) to turbine housing outlet with V-band clamp. Tighten clamp to 20 N·m (15 lb-ft). 7. Install exhaust elbow (A). Apply PT569 NEVER-SEEZ Compound to mounting cap screws and tighten to 24 N·m (18 lb-ft). 8. Install air intake hose and tighten hose clamps securely. IMPORTANT:

BEFORE STARTING an engine with a new or repaired turbocharger, crank the engine over (but do not start) for several seconds to allow engine oil to reach turbocharger bearings. DO NOT crank engine longer than 30 seconds at a time to avoid damage to starting motor. 30 21 9. Start and run engine at low idle while checking oil inlet and air piping connections for leaks. CTM42 (24MAR95) 30-21 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G30,39-19-24MAR95 160101 PN=266