John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Remove and Disassemble Horizontally-Mounted Aftercooler Assembly REMOVE AND DISASSEMBLE HORIZONTALLY-MOUNTED AFTERCOOLER ASSEMBLY (6076A ENGINES) NOTE: On some applications, aftercooler may be mounted vertically on engine. Specifications are the same regardless of how aftercooler is mounted. 1. Completely drain engine coolant from aftercooler. RG6486 -UN-26OCT92 RG6487 -UN-26OCT92 2. Disconnect turbocharger oil inlet (A) and return (B) lines. 3. Remove four turbocharger-to-exhaust manifold cap screws. 4. Remove coolant inlet and outlet hoses (C) from aftercooler. 5. Remove top three intake manifold cap screws. Install guide studs at the three locations.

Remove remaining cap screws. 6. Remove intake manifold and aftercooler as an assembly. 7. Remove and discard intake manifold gaskets. 8. Remove turbocharger from aftercooler cover. RG,CTM42,G30,55-19-29OCT92 9. Install JDG683 Sealing Ring Compression Tool (A) onto aftercooler coolant tubes with cross bar across slot. 10. Remove intake manifold cover (B). 11. Remove JDG683 tool. 12. Remove aftercooler core from intake manifold. 30 25 13. Inspect aftercooler end seal and replace as needed. RG6488 -UN-26OCT92 14. Inspect and repair aftercooler. See INSPECT AND REPAIR AFTERCOOLER (6076A ENGINES), as described earlier in this group. CTM42 (24MAR95) 30-25 6076 Diesel Engines—S.N.

(500000— ) RG,CTM42,G30,59-19-29OCT92 160101 PN=270