Air Intake And Exhaust System/Install Intake Manifold and Vertically-Mounted Aftercooler 3. Install a new gasket (A) on top of intake manifold. 4. Install aftercooler end seal (B) on inlet and outlet tubes. 5. Install aftercooler on top of intake manifold. Put a new gasket on top of aftercooler. Carefully align cap screw holes in aftercooler, intake manifold, and gaskets. RG5864 -UN-13AUG91 RG,CTM42,G30,51-19-29OCT92 6. Install air intake cover (A) over aftercooler so inlet and outlet tubes are protruding through hole in cover. IMPORTANT: Improperly seated or crimped end seal can result in loss of power and possible engine damage. Make sure end seal is properly seated. 7.
Install JDG683 Sealing Ring Compression Tool (B) onto aftercooler coolant tubes (C) with crossbar across slot as shown. 8. Tighten tool until air intake cover cap screw holes are aligned with holes in gaskets, aftercooler, and intake manifold. IMPORTANT: All intake manifold and aftercooler connections at the turbocharger and engine cylinder head must be tight to prevent loss of power resulting from lower manifold pressure, and possible engine damage. RG5570 -UN-09JAN90 9. Apply PT569 NEVER-SEEZ to all intake manifold-to-aftercooler cover cap screws. Install cap screws and tighten to 34 N·m (25 lb-ft). Remove seal compression tool.
30 28 RG,CTM42,G30,52-19-14FEB95 CTM42 (24MAR95) 30-28 6076 Diesel Engines—S.N. (500000— ) 160101 PN=273