John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Assemble and Install Horizontally-Mounted Aftercooler Assembly ASSEMBLE AND INSTALL HORIZONTALLY-MOUNTED AFTERCOOLER ASSEMBLY (6076A ENGINES) RG6489 -UN-26OCT92 A—Gasket (3 Used) F—Aftercooler Core K—Pipe Plug O—Hose B—Intake Manifold G—O-Ring L—End Seal P—Nipple (2 Used) C—Washer (6 Used) H—Intake Coupler M—Clamps (4 Used) Q—Cap Screw (12 Used) D—Cap Screw (6 Used) I—O-Ring N—Hose R—Washer (12 Used) E—Gasket (2 Used) J—Aftercooler Cover IMPORTANT: Improperly seated or crimped aftercooler end seal can result in loss of power and possible engine damage. Make sure end seal is properly seated. 3.

Install JDG683 Sealing Ring Compression Tool onto aftercooler coolant tubes with cross bar across slot. 4. Tighten tool until intake manifold cover cap screw holes are aligned with holes in gaskets, aftercooler, and intake manifold. Use guide studs as needed to hold alignment. 1. Install aftercooler end seal on coolant tubes. IMPORTANT: Debris left in intake manifold can cause engine damage. Make sure that inside of manifold is clean before assembly. 5. Apply PT569 NEVER-SEEZ Compound to all aftercooler cover-to-intake cap screws. Tighten cap screws to 34 N·m (25 lb-ft). Remove seal compression tool. 2. Position aftercooler core into intake manifold using new gaskets. 30 29 6.

Apply multi-purpose grease to turbocharger compressor O-ring and install turbocharger onto aftercooler cover. CTM42 (24MAR95) 30-29 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G30,57-19-16AUG94 160101 PN=274