Air Intake And Exhaust System/Remove, Inspect, and Install Exhaust Manifold REMOVE, INSPECT, AND INSTALL EXHAUST MANIFOLD NOTE: On 6076 HRW 33, 34, and 35 Engines, exhaust manifold can be removed without removing intake manifold. RG5865 -UN-13AUG91 RG6338 -UN-03AUG92 1. Remove turbocharger, air intake and manifold assembly as described earlier in this group. 2. Remove turbocharger oil return pipe (D). 3. Remove cap screws and lift off front exhaust manifold (A) and rear exhaust manifold (B). 4. Remove and discard front-to-rear exhaust manifold sealing ring (C). 5. Remove all residue and gasket material from gasket surfaces. 6. Thoroughly clean passages in exhaust manifolds and exhaust elbow.
7. Inspect each exhaust manifold for cracks or damage. Inspect machined mounting surfaces for burrs or other defects which might prevent gaskets from sealing properly. Replace parts as necessary. A—Front Exhaust Manifold B—Rear Exhaust Manifold C—Sealing Ring 8. To install exhaust manifold, reverse removal procedure D—Turbocharger Oil Return Pipe and use new gaskets. 9. Coat exhaust manifold cap screws with PT569 NEVER-SEEZ Compound and tighten to 47 N·m (35 lb-ft) in sequence as shown. 30 31 RG,CTM42,G30,53-19-14FEB95 CTM42 (24MAR95) 30-31 6076 Diesel Engines—S.N. (500000— ) 160101 PN=276