Fuel System/Inspect and Repair Mechanical Fuel Supply Pump (Nippondenso) NOTE: Spindle/seal O-ring (B) is pressed into pump housing. This seal keeps diesel fuel from leaking past spindle (A) and entering injection pump crankcase. 8. Remove spindle seal from housing using needle nose pliers. Discard seal. RG4029 -UN-30NOV88 S55,3010,AA -19-03OCT92 INSPECT AND REPAIR MECHANICAL (ROLLER TAPPET) FUEL SUPPLY PUMP COMPONENTS—NIPPONDENSO 1. Inspect supply pump housing for cracks and wear. Be sure valve seating areas are not pitted. Replace housing as necessary. RG5902 -UN-19AUG91 2. Check roller tappet and plunger bore for wear and scoring. Remove any deposits in housing with a suitable solvent.
Rinse housing in clean diesel fuel. 3. Check condition of threads for inlet and outlet fittings. Pump elbow fittings have 1/2-20 threads. RG,CTM42,G35,11-19-14FEB95 4. Inspect roller (A) OD for excessive wear. Be sure roller turns freely on pin (B) and in tappet (C). RG2321 -UN-30NOV88 5. Inspect sliding blocks (D). Edges should be square and unpitted. Blocks should slide in and out of tappet easily. 6. Inspect tappet for wear and scoring. Remove any deposits with a suitable solvent. 35 14 Be sure land on tappet that contacts pressure spindle is flat and undamaged. A—Roller B—Pin C—Tappet D—Sliding Block (2 used) CTM42 (24MAR95) 35-14 6076 Diesel Engines—S.N.
(500000— ) S11,3010,QN -19-24NOV86 160101 PN=291