John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System/Install Mechanical Fuel Supply Pump ASSEMBLE MECHANICAL (FLAT PLUNGER) FUEL SUPPLY PUMP—ROBERT BOSCH IMPORTANT: Always use new copper gaskets and O-rings. Dip parts in clean diesel fuel before assembly. Hands should be wet with diesel fuel when assembling internal components of fuel supply pump. RG5946 -UN-28AUG91 1. Assemble seal (B) into plunger (C) so flat side of seal is against closed end of plunger. Install inlet valve (A) into plunger so spring side of valve protrudes through center of seal and faces toward closed end of plunger. 2. To assemble supply pump, reverse disassembly procedure using new O-rings and copper washer. Perform leak test described in Group 115.

RG,CTM42,G35,67-19-14FEB95 INSTALL MECHANICAL FUEL SUPPLY PUMP IMPORTANT: Before installing supply pump, test pump to make sure fuel will not leak around spindle and spindle seal. (See TEST MECHANICAL FUEL SUPPLY PUMP FOR LEAKS, in Group 115.) RG5906 -UN-19AUG91 1. On Nippondenso (roller tappet) pumps, put a new O-ring in counterbore of injection pump housing next to fuel supply pump mounting face. On Robert Bosch pumps, install a new gasket on supply pump mounting face (A). Bosch pump shown 2. Position pump over mounting studs. Tighten mounting stud nuts 5—7 N·m (4—5 lb-ft) (45—60 lb-in.). 35 18 3. Install fuel inlet and outlet lines when engine is installed in vehicle.

Tighten all connections securely. 4. Bleed fuel system. (See BLEED THE FUEL SYSTEM, in Group 115.) CTM42 (24MAR95) 35-18 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G35,14-19-14FEB95 160101 PN=295