John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System/Remove In-Line Fuel Injection Pump REMOVE IN-LINE FUEL INJECTION PUMP IMPORTANT: Never steam clean or pour cold water on an injection pump while pump is running, or while it is still warm. To do so may cause seizure of pump parts. RG5873 -UN-19AUG91 1. Clean injection lines and area around the injection pump with cleaning solvent or a steam cleaner. NOTE: Follow same removal procedure for injection pumps equipped with mechanical governor and electronic governor. Differences will be noted. 2. Remove timing hole plug (A, shown removed). 3. Rotate engine flywheel (in normal running direction) until No. 1 piston is at “TDC” of its compression stroke.

At this point, JDE81-4 Timing Pin should enter hole in flywheel. 4. Timing marks on injection pump drive hub (B) and timing pointer (C) should be in alignment. RG,CTM42,G35,73-19-28OCT92 35 26 CTM42 (24MAR95) 35-26 6076 Diesel Engines—S.N. (500000— ) 160101 PN=303