Fuel System/Remove In-Line Fuel Injection Pump NOTE: Remove alternator at this time if not previously removed. 5. Remove injection pump drive gear cover (shown removed), remove and discard all gasket material. RG7283 -UN-07FEB95 RG5875 -UN-19AUG91 NOTE: In some situations JDG886 Injection Pump Timing Pin cannot be installed. 6. Install JDG886 Injection Pump Timing Pin through injection pump drive gear into injection pump hub until it bottoms. In some instances it may be necessary to rotate the pump drive hub slightly to get the pin installed. 7. Remove injection pump drive gear cap screws. 8. Disconnect injection pump lube line (B) from cylinder block fitting. Remove oil filter (C). 9.
On standard governor pumps, remove fuel shutoff solenoid (not shown) from oil filter housing. (See REMOVE AND INSTALL FUEL SHUTOFF SOLENOID, earlier in this group.) 10. Remove fuel inlet line (D). Remove fuel leak-off line (E). 11. Disconnect fuel supply pump lines (F). Photo shows A—JDG886 Injection Pump Timing Pin only one line. B—Injection Pump Lube Line C—Oil Filter D—Fuel Inlet Line 12. Disconnect aneroid line (G), if equipped. E—Leak-Off Line F—Fuel Supply Pump Lines G—Aneroid Line RG,CTM42,G35,18-19-14FEB95 NOTE: For injection pumps equipped with electronic governors (A), disconnect wiring harness at governor and shut-off solenoid (B).
Protect connectors on wiring harness while pump is disconnected so debris does not enter connector ends. 35 27 RG5876 -UN-19AUG91 CTM42 (24MAR95) 35-27 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G35,19-19-10SEP91 160101 PN=304