Fuel System/Remove In-Line Fuel Injection Pump 13. Remove fuel injection line nuts (A). On Robert Bosch “P” injection pumps use JDE90 Serrated Wrench (B) with either JDF22 Crowsfoot Wrench (C) or a standard 3/4 in. Line Wrench (D). RG5877 -UN-19AUG91 RG5878 -UN-19AUG91 On Nippondenso “P” injection pumps, use a 22 mm Open End Wrench with either the 3/4 in. line wrench or Crowsfoot Wrench mentioned above. IMPORTANT: JDE-90 Serrated Wrench (Robert Bosch) and 22 mm Open End Wrench (Nippondenso) must be used to keep delivery valve fittings stationary while loosening line nuts.
If a delivery valve and barrel housing rotates while loosening or tightening a fuel line nut, injection pump delivery will be altered. The pump will have to be recalibrated on a test stand. 14. Remove four mounting stud nuts which secure injection pump to cylinder block. 15. Carefully remove injection pump and place it on a clean flat surface. A—Fuel Injection Line Nuts B—JDE-90 Serrated Wrench C—JDF-22 Crowsfoot Wrench D—3/4 in. Line Wrench RG,CTM42,G35,20-19-14FEB95 35 28 CTM42 (24MAR95) 35-28 6076 Diesel Engines—S.N. (500000— ) 160101 PN=305