Fuel System/Install In-Line Fuel Injection Pump 3. Rotate injection pump drive hub until marks on drive hub (B) and pointer (A) are aligned. NOTE: It may be necessary to rotate pump hub slightly to allow JDG886 Timing Pin (E) to enter bearing plate. RG7741 -UN-07SEP94 4. Thread JDG886 Timing Pin into drive hub as shown, and tighten until it bottoms against bearing plate (D). 5. Install a new O-ring (C) on bearing plate. Lightly lubricate O-ring with AR54749 Soap Lubricant to aid in pump installation and prevent O-ring damage. IMPORTANT:
“A” Series injection pumps must be A—Pointer B—Drive Hub installed straight (upright) on the C—O-Ring engine to assure correct alignment of D—Bearing Plate fuel shutoff solenoid linkage. E—JDG886 Timing Pin Misaligned linkage will bind and not allow shutoff solenoid to operate properly, if pump is incorrectly installed. Pump is correctly aligned if linkage can be moved freely back and forth. 6. Install injection pump using moderate forward pressure and slight rocking motion to work O-ring into mounting bore. Injection pump flange should seat solidly against cylinder block. 7. Install mounting stud nuts and tighten to 47 N·m (35 lb-ft).
RG,CTM42,G35,74-19-14FEB95 35 30 CTM42 (24MAR95) 35-30 6076 Diesel Engines—S.N. (500000— ) 160101 PN=307