John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System/Install In-Line Fuel Injection Pump 8. Place injection pump drive gear in timing gear housing (if previously removed) with chamfered side of gear toward injection pump. Chamfer is at outer edge of bore for easier installation of gear to pump drive hub. 9. Carefully install drive gear on pump drive hub, position gear so mounting cap screws are approximately centered in mounting slots. This will allow for minor adjustment of pump timing, should the need arise. RG7283 -UN-07FEB95 10. Install drive gear-to-pump hub cap screws (C) and tighten to: —47 N·m (35 lb-ft) on “A” pumps —61 N·m (45 lb-ft) on “P” pumps 11. Remove JDG886 Timing Pin (A) from injection pump hub.

Install timing hole plug using LOCTITE 242 (TY9370) Thread Lock and Sealant, tighten plug securely. 12. Install injection pump drive gear cover using a new gasket, tighten cap screws to 27 N·m (20 lb-ft). RG,CTM42,G35,21-19-14FEB95 NOTE: Remove protective caps and plugs that were installed on fuel system components during injection pump removal. 13. Connect fuel delivery lines using JDE90 Serrated Wrench (B) and JDF22 Crowsfoot Wrench (C). Tighten line nuts (A) to 27 N·m (20 lb-ft). RG5877 -UN-19AUG91 IMPORTANT: DO NOT move delivery valve fittings while tightening line nuts.

If delivery valve and barrel housing rotates while tightening a fuel line nut, injection pump fuel delivery will be altered. The injection pump will have to be recalibrated on a test stand by an authorized diesel repair station. 35 31 RG,CTM42,G35,23-19-03OCT92 CTM42 (24MAR95) 35-31 6076 Diesel Engines—S.N. (500000— ) 160101 PN=308