Fuel System/Install Rotary Fuel Injection Pump—Stanadyne DB4 2. Position injection pump drive gear in timing gear cover so “V” mark (A) on gear aligns with “V” mark (B) on drive gear access opening. 3. Lubricate injection pump mounting flange O-ring with AR54749 Soap Lubricant before installing pump on engine. RG6464 -UN-26OCT92 RG,CTM42,G35,88-19-16AUG94 Make sure index pin is installed in pump shaft. Replace pump drive shaft and/or pin as necessary. IMPORTANT: DO NOT drop shaft nut or washer into timing gear area while installing injection pump. 4. Install injection pump onto cylinder block mounting studs until pump flange is square to cylinder block.
Retain shaft in gear with nut and washer. Install stud nuts with washers and finger tighten. RG6463 -UN-26OCT92 RG6465 -UN-26OCT92 • Injection Pump Timing: NOTE: DO NOT use window on side of injection pump to time DB4 pumps; there are no internal timing marks. 5. Index injection pump so timing marks (A) on pump flange and cylinder block face align. 6. Tighten injection pump mounting nuts to 47 N·m (35 lb-ft). 7. Tighten injection pump drive gear-to-shaft nut to 142 N·m (105 lb-ft). 35 35 CTM42 (24MAR95) 35-35 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G35,89-19-16AUG94 160101 PN=312