John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System/Remove Fuel Injection Nozzles REMOVE FUEL INJECTION NOZZLES General Nozzle Service Precautions: 1. Thoroughly clean area around injection pump and nozzles, including all line connections, using compressed air. RG5877 -UN-19AUG91 RG5878 -UN-19AUG91 2. Cap or plug all fuel lines as they are disconnected to prevent dirt and debris from entering fuel system. Debris in fuel system can plug injectors and cause engine damage. On In-Line Injection Pumps: 3. Disconnect injection lines from injection pump using JDF22 Crowsfoot Wrench. IMPORTANT:

On “P” injection pumps, JDE90 Serrated Wrench (Robert Bosch) (B) and 22 mm Open End Wrench (Nippondenso) must be used to keep delivery valve fittings stationary while loosening line nuts. If a delivery valve and barrel housing rotates while loosening or tightening a fuel line nut, injection pump delivery will be altered. Pump must be recalibrated on a test A—Fuel Injection Line Nuts stand. B—JDE90 Serrated Wrench C—JDF22 Crowsfoot Wrench D—3/4 in. Line Wrench 4. Remove fuel injection line nuts (A). On Robert Bosch “P” injection pumps use JDE90 Serrated Wrench with either JDF22 Crowsfoot Wrench (C) or a standard 3/4 in. Line Wrench (D).

On Nippondenso “P” injection pumps, use a 22 mm Open End Wrench with either JDF22 Crowsfoot Wrench or equivalent crowsfoot wrench mentioned above. On “A” injection pumps, use either JDF22 Crowsfoot Wrench or an equivalent crowsfoot wrench. 35 37 RG,CTM42,G35,96-19-28OCT92 CTM42 (24MAR95) 35-37 6076 Diesel Engines—S.N. (500000— ) 160101 PN=314