John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System/Disassemble Fuel Injection Nozzle DISASSEMBLE FUEL INJECTION NOZZLE General Nozzle Repair Notes: NOTE: Disassembly of nozzles is not recommended unless servicing is indicated by nozzle operation and testing. • Since dirt and water are the worst contaminants in fuel injection system, working area, tools and cleaning materials must be kept spotlessly clean. Whenever possible, work in an isolated, dust-free area. • Cover workbench with clean paper before disassembly of injection nozzles. • As parts are disassembled, place them in a pan of clean diesel fuel and leave there until needed. Do not permit parts to strike each other.

• Use a separate pan of clean diesel fuel for washing parts before assembly. S11,0408,AR -19-08APR94 NOTE: Bosch KDEL and Nippondenso KDAL injection nozzles are metric units. Only metric tools should be used. 1. Use a 11 mm box or open-end wrench and unscrew leak-off connector (A) (if not removed previously) out of nozzle holder (B). RG5884 -UN-19AUG91 2. Clamp flats of nozzle holder in a soft jawed vise. Remove nozzle retaining nut (C) from nozzle holder using a 12-point 19mm wrench. 3. Slip gland nut (D) off nozzle holder. NOTE:

Bosch nozzles have a snap ring and O-ring at A—Leak-Off Connector B—Nozzle Holder top of gland nut that must be removed before C—Nozzle Retaining Nut gland nut can be removed. After removing gland D—Gland Nut nut, lower snap ring can be removed. 35 47 CTM42 (24MAR95) 35-47 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G35,50-19-03OCT92 160101 PN=324