Fuel System/Perform Chatter and Spray Pattern Test IMPORTANT: Do not lap the machined surfaces (A) of the intermediate plate in an attempt to stop fuel leakage at these locations. Dowels (spring pins) (B) in plate have to be removed before surfaces can be lapped. Removing dowels is not recommended as removal is likely to damage them, and replacement dowels are not available as service parts. RG2248 -UN-20APR89 If leakage is observed, tighten nozzle retaining nut to a maximum of 79 N·m (58 lb-ft). Replace injection nozzle if leakage continues. S11,0408,AP -19-08APR94 PERFORM CHATTER AND SPRAY PATTERN TEST 1.
Injection nozzle should chatter very softly, and only when hand lever movement is very rapid (four to six downward movements per second). Failure to chatter may be caused by a binding or bent nozzle valve. 2. Until chattering range is reached, the test oil emerges as non-atomized streams. When lever movement is accelerated, sprays should be very broad and finely atomized. A partially clogged or eroded orifice will usually cause spray to deviate from the correct angle. Spray will also be steady rather than finely atomized. 3. Disassemble nozzle for cleaning or reconditioning if it fails to chatter or spray properly.
35 46 RG,CTM42,G35,33-19-03OCT92 CTM42 (24MAR95) 35-46 6076 Diesel Engines—S.N. (500000— ) 160101 PN=323