John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System/Clean and Inspect Fuel Injection Nozzle Assembly CLEAN AND INSPECT FUEL INJECTION NOZZLE ASSEMBLY IMPORTANT: Never use a steel brush to clean nozzles. Steel brush may damage injection nozzles. RG3411 -UN-20DEC88 1. Remove anti-corrosive coating from new or reconditioned nozzles by washing them thoroughly with diesel fuel. 2. Remove carbon from used nozzles and clean by washing them in diesel fuel. If parts are coated with hardened carbon or lacquer, it may be necessary to use a brass wire brush. 3. After removing carbon or lacquer from nozzle exterior, inspect lapped surface for nicks or scratches. Replace if not in good condition. 4.

Inspect piston part of nozzle valve (A) to see that it is not scratched or scored. If any of these conditions are present, replace nozzle assembly. 5. Inspect nozzle valve seat, nozzle, and intermediate plate. Contact area of parts (B) must not be scored or pitted. Use inspection magnifier in JDF13 (JDE105) Nozzle Cleaning Kit to aid inspection. NOTE: A bad nozzle valve seat will cause fuel to drip from nozzle. This condition will usually be noted when making the “Leakage Test”. S11,0408,AU -19-08APR94 35 49 CTM42 (24MAR95) 35-49 6076 Diesel Engines—S.N. (500000— ) 160101 PN=326