Fuel System/Clean Spray Orifices PERFORM NOZZLE SLIDE TEST NOTE: DO NOT touch lapped surface (D) unless hands are wet with diesel fuel. 1. Dip nozzle valve (A) in clean diesel fuel. 2. Insert valve in nozzle (B). 3. Hold nozzle vertical and pull valve out about one-third of its engaged length. RG5953 -UN-30AUG91 4. Release valve. Valve should slide down (C) to its seat by its own weight. Always replace a nozzle assembly if valve does not fall freely to its seat. A—Nozzle Valve B—Nozzle C—Free-Fall Distance D—Lapped Surface RG,CTM42,G35,53-19-03OCT92 CLEAN SPRAY ORIFICES 1. Begin with cleaning wire (D) 0.07—0.10 mm (0.003—0.004 in.) from JDF13 (JDE105) Nozzle Cleaning Kit.
RG5954 -UN-30AUG91 NOTE: Stoning wire to provide a flat surface on one side will help in reaming carbon from clogged hole. 2. Clamp cleaning wire in pin vise (A). Wire should not protrude from vise more than 0.8 mm (1/32 in.). 3. Insert wire into orifice (C) and rotate. 4. For final cleaning, use cleaning wire 0.03 mm (0.001 A—Pin Vise B—Nozzle in.) smaller than orifice size. Follow previous steps until C—Orifice orifices are clean of any carbon deposits. D—Cleaning Wire RG,CTM42,G35,54-19-05APR93 35 50 CTM42 (24MAR95) 35-50 6076 Diesel Engines—S.N. (500000— ) 160101 PN=327