John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System/Inspect Nozzle Holder INSPECT NOZZLE HOLDER RG5959 -UN-30AUG91 A—Lapped Surface C—M19 x 0.75 D—M6 x 1 E—M14 x 1.5 B—Nozzle Holder 1. Inspect lapped surface (A) on bottom end of nozzle holder (B) for nicks or scratches. Replace holder if not in good condition. 4. Remove carbon deposits on both inner and outer surfaces of nozzle retaining nut. 5. Inspect retaining nut for cracks caused by overtightening or a damaged lower seating surface. A seat may be restored by rubbing the surface with emery cloth. Any nozzle nut which cannot be reconditioned, must be replaced. 2. Inspect threads M19 x 0.75 (C), M6 x 1 (D), and M14 x 1.5 (E) on nozzle holder for general condition.

Threads that are nicked slightly may be “dressed-up.” Replace holder if threads cannot be restored to a serviceable condition. 3. Check fuel passages in nozzle holder to make sure they are open. Clean with compressed air. RG,CTM42,G35,55-19-03OCT92 35 51 CTM42 (24MAR95) 35-51 6076 Diesel Engines—S.N. (500000— ) 160101 PN=328