John Deere 400 6076 — John Deere 400 6076 User Manual

Engine System Operation and Test/General Engine Description GENERAL ENGINE DESCRIPTION All 6076 Engines are vertical stroke, in-line, valve-in-head, 6-cylinder diesel engines. The cylinder firing order is 1-5-3-6-2-4. The crankshaft is a one-piece, heat treated, dynamically balanced steel forging which rotates in replaceable two-piece main bearings. The rear thrust bearing has a flange on each side to reduce crankshaft deflection and to limit end play during high load operation. On 6076 Engines, direct fuel injection is provided by an in-line injection pump and 21 mm injection nozzles mounted in cylinder head.

The pump is driven by an intermediate gear in the timing gear train meshing with the camshaft gear. Cylinder liners are of a wet sleeve, flanged, and centrifugally cast design. O-rings are used to seal the connection between cylinder block and liners. Liners are induction hardened and are individually replaceable. The pump has an engine-driven camshaft which rotates at one-half engine speed. Roller cam followers, riding on the camshaft lobes, operate the plungers to supply high-pressure fuel through the delivery valves to the injection nozzles. A governor-operated control rack is connected to the control sleeves and plungers to regulate the quantity of fuel delivered to the engine.

Pistons are constructed of high-grade cast aluminum alloy and are cam ground. A double Ni-Resist ring carrier is cast integrally in the piston to greatly improve the life of the two ring grooves. A deep combustion chamber design provides maximum combustion efficiency. Pistons have a three ring combination. The top two rings are compression rings and the lower ring is an oil control ring. All engines are turbocharged. Operated by exhaust gases, the turbocharger compresses intake air from air cleaner and routes it to each cylinder’s combustion chamber. The highly polished, hardened piston pins are fully-floating and held in position by means of snap rings.

Spray jets (piston cooling orifices) in cylinder block direct pressure oil to lubricate piston pins and cool pistons. An air-to-air aftercooler cools the turbocharger compressor discharge air by routing it through a heat exchanger (usually mounted in front of radiator) before it enters the intake manifold. The heat exchanger uses no liquid coolant, but relies on air flow to cool the charge air. Connecting rods are of forged steel and have replaceable bushing and bearing inserts. They are weight controlled (by machining) on both ends to minimize engine vibration. The camshaft and followers are made of chilled iron.

The cam lobes are individually flame hardened to provide excellent wear characteristics. Spherically ground followers riding on tapered cam lobes help insure positive follower rotation. The engine is supplied with lubricating oil by a spur gear pump driven off the rear of the crankshaft. Oil is conditioned in a housing located on the right side of the engine. Oil temperature is limited by an oil cooler and filtered by a full flow oil filter. Individual cooler and filter bypass valves protect the system and ensure engine lubrication during times of high restriction; such as cold starts. Oil pressure is controlled by a pressure regulating valve located before the gallery.

Intake and exhaust valves are operated by cam followers, push rods, and rocker arm assembly. Cylinder heads have replaceable inserts and valves, and have positive rotators for both intake and exhaust valves. 105 5 CTM42 (24MAR95) 105-5 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G1,5 -19-29OCT92 160101 PN=354