John Deere 400 6076 — John Deere 400 6076 User Manual

Engine System Operation and Test/How the Lubrication System Works HOW THE LUBRICATION SYSTEM WORKS NOTE: Refer to illustration on following page. A separate illustration of the oil conditioning housing assembly is found later in this group. From the main oil gallery, cooled clean oil is pressure fed to the main and rod bearings (G), piston cooling orifices, and camshaft bushings (H). Oil from the front camshaft bushing is fed through a drilled hole in the camshaft nose and lubricates the camshaft thrust washer and splash lubes the front gears. The injection pump is pressure lubed off of the main gallery.

The engine lubrication system consists of a gear-driven (crankshaft), positive displacement pump (O), oil cooler (A), oil filter (C), cooler bypass valve (B), filter bypass valve (D), and oil pressure regulating valve (E). Oil from the rear camshaft bushing is fed through a drilling in the cylinder block and cylinder head and up to the rocker arm shaft. Oil from the shaft is distributed to the rocker arms. Oil from the rocker arms lubricates the other valve train components and camshaft followers. Oil is drawn up from the oil pan through the oil pump. After it leaves the oil pump, oil flows to the oil cooler through a machined passage in the cylinder block.

The oil conditioning housing (V) contains the oil cooler bypass valve, oil filter bypass valve, oil pressure regulating valve, and the engine oil filter. Oil then proceeds through the oil cooler where it exchanges heat with the coolant. Clean oil from the oil filter goes to the turbocharger oil inlet line (K) and is returned through the turbocharger oil return tube (L). Oil completes the circuit by returning to the oil pan. If high restriction is sensed, such as during a cold start, oil bypasses the oil cooler through the cooler bypass valve and goes directly to the oil filter. If excessively high restriction is sensed at the filter, oil is diverted directly to the regulating valve.

After flowing past the regulating valve; pressurized, cooled clean oil is supplied to the main oil gallery. Oil is then distributed, under pressure, to each main bearing (F) and piston cooling orifice (I). Oil from the piston cooling orifices lubricates the piston pin and bushing (J) through a hole in the top of the connecting rod. The regulating valve permits excess oil to be diverted back to the oil pan. CTM42,G105,20 -19-29OCT92 105 6 CTM42 (24MAR95) 105-6 6076 Diesel Engines—S.N. (500000— ) 160101 PN=355