John Deere 400 6076 — John Deere 400 6076 User Manual

Engine System Operation and Test/Diagnosing Head Gasket Joint Failures 2. Obtain coolant and oil samples for further analysis. 4. Shut engine down. Recheck crankcase, radiator, and overflow tank for any significant differences in fluid levels, viscosity, or appearance. 3. Start and warm up engine if it can be safely operated. Examine all potential leakage areas again as outlined previously. Using appropriate test and measurement equipment, check for the following: 5. Compare your observations from above steps with the following diagnostic charts.

If diagnostic evaluations and observations provide conclusive evidence of combustion gas, coolant, or oil leakage from head gasket joint, the cylinder head must be removed for inspection and repair of gasket joint components. • White smoke, excessive raw fuel, or moisture in exhaust system. • Rough, irregular exhaust sound, or misfiring. • Air bubbles, gas entrainment in radiator or overflow tank. • Loss of coolant from overflow. • Excessive cooling system pressure. • Coolant overheating. • Low coolant flow. • Loss of cab heating (air lock). RG,CTM8,G105,11-19-29OCT92 Combustion Seal Leakage Symptoms: Possible Causes:

• Exhaust from head gasket crevice • Insufficient liner standout • Air bubbles in radiator/overflow tank • Excessive liner standout differential between cylinders • Coolant discharge from overflow tube • Low head bolt clamping loads • Engine overheating • Rough/damaged liner flange surface • Power loss • Cracked/deformed gasket combustion flange • Engine runs rough • Out-of-flat/damaged/rough cylinder head surface • White exhaust smoke • Missing/mislocated gasket fire ring • Loss of cab heat • Block cracked in liner support area • Gasket section dislodged, missing (blown) • Excessive fuel delivery • Coolant in cylinder • Advanced injection pump timing • Coolant in crankcase oil • Hydraulic or mechanical disturbance of combustion seal • Low coolant level NOTE:

Cracked cylinder head or liners may also allow combustion gas leakage into coolant. RG,CTM8,G105,12-19-16SEP92 105 15 CTM42 (24MAR95) 105-15 6076 Diesel Engines—S.N. (500000— ) 160101 PN=364