Engine System Operation and Test/Test Engine Compression Pressure TEST ENGINE COMPRESSION PRESSURE RG4118 -UN-27OCT88 IMPORTANT: Compression pressures are affected by the cranking speed of the engine. Before beginning test, insure that batteries are fully charged and injection nozzle area is thoroughly cleaned. NOTE: Pressure given was taken at 300 m (1000 ft) above sea level. A 3.6 percent reduction in gauge pressure will result for each additional 300 m (1000 ft) of altitude. All cylinder pressures should be approximately alike. There should be less than 340 kPa (3.4 bar) (50 psi) difference between cylinder pressures. 1.
Start engine and run at rated speed until it warms up to normal operating temperature. (From a cold start, operate engine 10—15 minutes at slow idle.) 7. If pressure is much lower than shown, remove gauge and apply oil to ring area of piston through injection nozzle bore. Do not use too much oil and do not get oil on valves. 2. Remove injection lines, leak-off lines, and injection nozzles. See Group 35. 3. Install the JT01675A Nozzle adapter and JT01677 Adapter Nut (A) into injection nozzle bore. Tighten adapter nut to 80 N·m (60 lb-ft). 8. Crank engine over and record compression reading again. 4. Connect JT01682 Gauge and Hose Assembly (B) to nozzle adapter.
If pressure is higher than 2790 kPa (27.9 bar) (405 psi), worn or stuck rings are indicated. Either replace piston rings or install new piston and liner set as needed. See Group 10. 5. Pull fuel shut-off knob all the way out, if equipped, and close fuel shut-off valve. If pressure is below 2380 kPa (23.8 bar) (345 psi), it is possible that valves are worn or sticking. Recondition cylinder head as needed. See Group 05. 6. Crank engine over at 275—325 rpm cranking speed and record compression readings. ENGINE COMPRESSION 9. Measure compression pressure in all remaining cylinders and compare readings. Recondition power cylinders and valves as required. Engine Compression Pressure 6076 . . . . .
. . . . . . . . . . . . . . 2380—2790 kPa (23.8—27.9 bar) (345—405 psi) 105 21 CTM42 (24MAR95) 105-21 6076 Diesel Engines—S.N. (500000— ) S55,22005,I -19-14FEB95 160101 PN=370