John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake System Operation and Test/Check Intake Manifold Pressure (Turbocharger Boost) CHECK INTAKE MANIFOLD PRESSURE (TURBOCHARGER BOOST) NOTE: For each vehicle application, refer to the appropriate machine technical manual for intake manifold pressure specifications. • If boost pressure is too high, remove and test fuel injection pump for high fuel delivery. 110 9 • If boost pressure is too low, check for the following: Intake manifold pressure (turbocharger boost) can be checked at intake manifold and aneroid. —Restriction in air cleaner. —Leak in air intake between turbocharger and cylinder head. —Defective turbocharger. —Leak in exhaust manifold gasket. —Leak in fuel control pipe.

—Restricted fuel filter elements. —Incorrect fast idle adjustment. —Incorrect injection pump timing. —Faulty fuel supply pump. —Low compression pressure. —Faulty fuel injection nozzles. —Carbon build-up in turbocharger. —Turbocharger compressor or turbine wheel rubbing housing. —Low fuel injection pump delivery. —Restricted exhaust. IMPORTANT: Engine speed and load should be stabilized before taking readings on gauge. Be sure that gauge works properly. Pressure checks are only a guide to determine if there is an engine problem (valve leakage, defective nozzles, etc.). Low readings are not a valid reason for increasing injection pump fuel delivery.

Pump adjustment should be within specification as established by an authorized repair station. RG,CTM42,110,6 -19-16AUG94 CTM42 (24MAR95) 110-9 6076 Diesel Engines—S.N. (500000— ) 160101 PN=382