Fuel System Operation and Test/Check and Adjust Rotary fuel pump Dynamic Timing Install JT07158 Time Trac Kit: IMPORTANT: All transducers and sensors must be installed at nozzle end of No. 1 fuel injection line. If access to No. 1 line is restricted, sensor can be installed on No. 6 injection line. RG7285 -UN-06FEB95 RG7286 -UN-13FEB95 Remove all paint from injection line where clamp-on transducer will be installed and be sure this location is thoroughly clean. 115 3 1. On engines with optional JT07155 In-Line SOI Sensor (A) installed between injection nozzle and fuel delivery line, install JT07173 SOI Clamp Assembly (B) onto clean sensor and tighten securely. 2.
On engines without optional JT07155 In-Line Sensor, install JT07177 6 mm (green) Clamp-on Transducer (E) onto clean, paint-free injection line and tighten securely. 3. Assemble red lead of JT07172 Transducer Cable (C) onto in-line sensor or transducer, however equipped. 4. Attach spring clip to a solid ground. Plug connector into JT07170 meter port marked SR. A—JT07155 In-Line SOI Sensor B—JT07173 SOI Clamp Assembly C—JT07172 Transducer Cable D—Fuel Injection (Delivery) Line E—JT07177 6 mm (Green) Clamp-on Transducer RG,CTM42,115,50-19-17MAR95 CTM42 (24MAR95) 115-3 6076 Diesel Engines—S.N. (500000— ) 160101 PN=386