John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System Operation and Test/Check and Adjust Rotary fuel pump Dynamic Timing 6. Run engine at 1300 rpm. Push ENTER. Display shows: Calibrating then Engine RPM and timing. NOTE: If display shows NO PROBE, the magnetic pick-up probe has not been installed properly [air gap exceeds 0.64 mm (0.025 in.)] or there is debris on the back of the flywheel. Check for proper air gap or to clean the back side of the flywheel, insert a soft wooden dowel into the engine timing pin hole with the engine running at low idle speed to clean the debris from flywheel. 115 7 7. Warm engine to normal operating temperature, check slow and fast idle rpm.

See FUEL INJECTION PUMP SPECIFICATIONS earlier in this group. Adjust speeds as necessary. RG,CTM8,G115,25-19-02FEB95 CTM42 (24MAR95) 115-7 6076 Diesel Engines—S.N. (500000— ) 160101 PN=390