John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System Operation and Test/Check and Adjust Rotary fuel pump Dynamic Timing IMPORTANT: Many machines have hydraulic pumps that have adequate flow to load engine well below rated load rpm. Some equipment may need to be driven in high gear or pull a load to bring engine speed to rated load rpm. RG7037 -UN-27SEP94 115 8 8. Run engine at wide open throttle (WOT) and load engine down gradually to rated speed rpm. NOTE: A negative timing value indicates the clamp-on sensor signal is not adequate. Check sensor and lines for cleanliness and proper installation. 9. Record engine speed (rpm) and timing degrees. IMPORTANT: Stop engine prior to making timing adjustments.

Injection pump can seize if adjustment is made with engine running. 10. Stop engine. If dynamic timing reading is more than 8 degrees retarded with pump flange and front plate timing marks at original location as shipped from factory, this may indicate the pump advance is not functioning. Check the following: • Change fuel filter(s) • Check transfer pump for positive fuel pressure to injection pump • Check camshaft movement on injection pumps with rectangular timing window. • Check pump drive shaft-to-gear key or pin to ensure key or pin has not sheared. • If none of the above checks are conclusive, remove pump and have necessary repairs made at an authorized diesel repair station.

RG,CTM8,G115,26-19-02FEB95 CTM42 (24MAR95) 115-8 6076 Diesel Engines—S.N. (500000— ) 160101 PN=391