Fuel System Operation and Test/Fuel System Operation—In-Line Fuel Injection Pump FUEL SYSTEM OPERATION—IN-LINE FUEL INJECTION PUMP 115 10 RG6665 -UN-13MAR93 A—Fuel Filter E—Supply Pump I—Fuel Shut-off Solenoid L—Injection Pressure B—Check Valve Assembly F—Injection Pressure Lines J—Supply Pump Outlet M—Supply Pump Pressure C—Pump Plungers G—Nozzles K—Round Primary N—Fuel Return D—Fuel Galley H—Leak-Off Line Filter/Water Separator O—Gravity Pressure The supply pump (E) draws fuel from the vented fuel tank through the primary filter (K). The high pressure fuel opens the nozzle valve and forces fuel out the small orifices in the nozzle tip.
This atomizes the fuel as it enters the combustion chamber. The supply pump pressurizes the fuel so that it flows through the filter (A) to the injection pump galley (D). Supply pump output pressure will vary depending on load and application. There are two sources of excess fuel incorporated into the system. The supply pump supplies more fuel to the pump than is required by the engine, and the nozzle requires excess fuel to lubricate the nozzle valve. A leak-off line (H) returns this excess fuel to the tank from both the pump and nozzles. The galley is kept full by the supply pump. Injection pump plungers (C) further pressurize the fuel.
Injection pressure lines (F) route the fuel to the nozzles (G). CTM42 (24MAR95) 115-10 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,115,3 -19-07APR93 160101 PN=393