Fuel System Operation and Test/Fuel System Operation—Rotary Fuel Injection Pump FUEL SYSTEM OPERATION—ROTARY FUEL INJECTION PUMP 115 11 RG6454 -UN-22OCT92 A—Electric Fuel Supply D—Injection Pressure Lines G—Fuel Supply Pump I—Fuel Return (Leak-off) Line Pump E—Fuel Injection Nozzles Pressure Pressure B—Fuel Filter F—Fuel Inlet Line H—Fuel Injection Pump C—Fuel Injection Pump Pressure The electric fuel supply pump (A) draws fuel from the tank and pressurizes it. This pressure permits the fuel to flow through the filter (B) and charge the transfer pump of the injection pump (C). Incorporated into the fuel system is a means of returning excess (or unused) fuel back to the fuel tank.
Excess fuel comes from two sources: 1. Fuel Injection Pump: A quantity of fuel greater than that required by the engine is supplies to the fuel injection pump. With the fuel injection pump charged with fuel by the fuel supply pump, the injection pump plungers pressurize the fuel to approximately 50 000 kPa (500 bar) (7255 psi). Injection pressure lines (D) are used to route this high pressure fuel to the fuel injection nozzles (E). 2. Fuel Injection Nozzles: A small amount of fuel seeps past the nozzle valve for lubrication purposes. To get the excess fuel back to the tank, a return line from the injection pump is connected to the middle of the nozzle leak-off line.
Fuel from both sources is then returned to the tank by a return pipe connected to the front end of the leak-off pipe. Fuel enters the injection nozzle at a pressure which easily overcomes the pressure required to open the nozzle valve. When the nozzle valve opens, fuel is forced out through the orifices in the nozzle tip and atomizes as it enters the combustion chamber. CTM42 (24MAR95) 115-11 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,115,33-19-28OCT92 160101 PN=394