John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System Operation and Test/Diagnose Fuel System Malfunctions DIAGNOSE FUEL SYSTEM MALFUNCTIONS NOTE: The following diagnostics apply to either standard mechanical in-line or rotary fuel pumps, or electronic governor type fuel pumps. See CTM11 for additional electronic pump diagnostics.

Symptom Problem Solution 115 12 Fuel Not Reaching Injection Fuel filter restricted Replace fuel filter (See Group 35) Nozzles Fuel line restricted Clean lines as required Fuel too heavy at low temperatures Use correct grade of fuel (See Group 02) Air in system Correct problem and bleed fuel system (this group) Fuel tank valve shut off Open fuel tank valve Low supply pump pressure Check fuel lines for restrictions; check pump output pressure (this group) Engine Starts Hard or Won’t Start Fuel too heavy at low temperature Use correct grade of fuel (See Group 02) Injection nozzles faulty or sticking Repair or replace as required (See Group 35) Incorrect timing Adjust timing (this group) Faulty injection pump Repair or replace Water in fuel Drain water from fuel (or separator if equipped).

Install new filter (See Group 35) Fuel filter restricted Replace fuel filters (See Group 35) Low supply pump pressure Check pump output pressure. (See this group) Injection pump return fuel line or Clean lines as required fittings restricted Low cetane fuel Use correct grade of fuel (See Group 02) Broken starting fuel control shaft Repair (See Group 35) spring Continued on next page CTM42 (24MAR95) 115-12 6076 Diesel Engines—S.N. (500000— ) 160101 PN=395