Fuel System Operation and Test/Check Mechanical Fuel Supply Pump Operation Test operation of suction side of pump: Test operation of discharge side of pump: 1. Disconnect suction and discharge lines at pump. 1. Suction line must be connected and discharge (pressure) line disconnected. 2. Drain all fuel from pump by operating hand primer. Then reconnect suction line to pump. 2. Tighten hand primer (Nippondenso only) and place injection pump fuel shut-off control in “STOP” position to prevent engine from starting. 3. Operate hand primer until fuel flows from pump outlet (discharge). Fuel should flow within 15—25 strokes.
If not, the suction line may be obstructed or leaking air; (replace in-line filter when used). 115 21 3. Crank engine with starting motor. Fuel should flow from pump outlet within 10 seconds. If not, the suction line may be obstructed or leaking air; (replace in-line filter when used). NOTE: When operating hand primer, a moderate resistance should be felt. When only a slight resistance (or no resistance) occurs, replace hand primer or repair pump (valves may be defective). If fuel does not flow, and if no leak or obstruction is found, pump is defective. Repair or replace pump. (See Group 35.) S11,23010,FJ -19-14FEB95 Test pump output pressure while cranking engine: 1.
Connect a 0—400 kPa (0—4 bar) (0—60 psi) pressure gauge to one end of a pressure hose about 250—300 mm (10—12 in.) long. Connect other end of hose to pump outlet. All air must be out of system. IMPORTANT: The starting motor must crank the engine at normal cranking speed. Use booster batteries if necessary. 2. Crank engine for 10 seconds with starting motor (approximately 300 engine rpm). Supply pump minimum outlet pressure should be 200 kPa (2.0 bar) (29.0 psi). RG5927 -UN-19AUG91 3. Compare measured output with the minimum pressure specifications. If pressure is below the minimum specified and if no obstruction or leak is found, repair or replace the pump.
CTM42 (24MAR95) 115-21 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,115,7 -19-17MAR95 160101 PN=404