Fuel System Operation and Test/Test Electric Fuel Supply Pump Output Pressure and Flow TEST ELECTRIC FUEL SUPPLY PUMP FOR OUTPUT PRESSURE AND FLOW Output Pressure Test: 1. Bleed fuel system. See BLEED FUEL SYSTEM later in this group. RG6481 -UN-26OCT92 2. Put key in “ON” position. 115 25 3. Connect pressure gauge to one end of pressure hose. Connect other end of hose to pump outlet. 4. Measure output pressure. ELECTRIC FUEL SUPPLY PUMP OUTPUT PRESSURE Normal . . . . . . . . . . . . . . . . 62—69 kPa (0.62—0.69 bar) 9—10 psi If output pressure is low, it may be the result of a partially obstructed supply pump filter screen. See CLEAN OR REPLACE ELECTRIC FUEL SUPPLY FILTER SCREEN in Group 35.
Flow Test: A clean fuel supply and a 12v power supply is needed for this test. 1. Disconnect fuel inlet line from supply line. 2. Connect pressure hose to pump inlet. Submerge the other end of hose in clean fuel. 3. With key in “ON” position, supply pumps should pump 3 qts. of fuel in 1 minute or 45 gallons per hour. If pump does not meet these specifications, see DIAGNOSING ELECTRIC SUPPLY PUMP MALFUNCTIONS earlier in this group. RG,CTM42,115,26-19-02NOV92 CTM42 (24MAR95) 115-25 6076 Diesel Engines—S.N. (500000— ) 160101 PN=408