Fuel System Operation and Test/Fuel Shut-Off Solenoid Resistance Test FUEL SHUT-OFF SOLENOID RESISTANCE TEST 1. Disconnect shut-off solenoid 3-way WEATHER PACK™ connector. 2. Measure “PULL” coil resistance between black lead wire “C” and white lead wire “B”. 115 27 3. Measure “HOLD” coil resistance between black lead wire “C” and red lead wire “A”. Replace solenoid if resistance is not within specification given below. PULL AND HOLD COIL RESISTANCE SPECIFICATIONS Solenoid Pull Coil Hold Coil Part Number Resistance Resistance (Ohms) (Ohms) 12-Volt System: RE53507, RE55415 . . . . . . 0.187—0.281 10.04—12.27 RE53559 . . . . . . . . . . . . . 0.140—0.210 6.63—8.11 24-Volt System:
RE54747, RE55416 . . . . . . 0.735—0.899 37.22—45.49 RE53560 . . . . . . . . . . . . . 0.560—0.684 24.35—29.76 WEATHER PACK is a trademark of Packard Electric. RG,CTM42,115,45-19-16AUG94 FUEL SHUT-OFF SOLENOID LINKAGE ADJUSTMENT RW19614 -UN-04DEC91 RW19615 -UN-04DEC91 Shut-off solenoid linkage is factory adjusted and usually will not require additional field adjustment. ALWAYS check linkage and lever for alignment and binding before making adjustments. 1. Thoroughly lubricate all linkage and lever pivot points. A—Link 2. If necessary, adjust linkage (A) so that lever (B) B—Lever contacts stop (C) with key switch “OFF” and engine not C—Stop D—Stop running. 3.
Start engine and run at slow idle. Lever should contact stop (D) or nearly contact when the lever is being pushed up. CTM42 (24MAR95) 115-27 6076 Diesel Engines—S.N. (500000— ) RG,CTM61,115,30-19-13MAY93 160101 PN=410