John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System Operation and Test/Check and Adjust Engine Slow Idle Speed—In-Line Fuel Injection Pump NOTE: On Nippondenso first remove slow idle stop screw cover. 2. Loosen lock nut (C) and back out the bumper spring adjusting screw (B) three turns. RG5943 -UN-23AUG91 3. Loosen lock nut (D) and adjust slow idle stop screw (A) to obtain an idle speed 50 rpm less that the desired slow idle speed setting. 115 36 4. Turn the bumper spring adjusting screw in to increase engine speed a maximum of 50 rpm to desired slow idle Robert Bosch (Nippondenso similar) speed.

For example, to obtain an 850 rpm slow idle speed, use A—Slow Idle Stop Screw the slow idle stop screw to set speed at approximately B—Bumper Spring Adjusting Screw 800 rpm. Then increase speed to 850 rpm using the C—Lock Nut bumper spring adjusting screw. D—Lock Nut NOTE: Increasing the slow idle speed a slight amount above the specified speed range may help to reduce engine surge (or hunting). If this occurs, use the procedure given above; but do not exceed 850 rpm. RG,CTM42,115,35-19-16AUG94 5. If engine surging or hunting persists at slow idle, the bumper spring (A) and adjustment screw (B) may need to be replaced with a new one.

Remove the pump from the engine and have it repaired by an authorized diesel repair station (ADS shop). See Group 35 for fuel injection pump removal and installation. R28387N -UN-14DEC88 6. Again check the fast and slow idle speeds. Readjust, slow idle speed if not correct. 7. Check all adjusting screw lock nuts for tightness. Install covers (and copper washers) on slow idle stop screw and idling spring adjusting screw (on Nippondenso Pumps). 8. Connect fuel shut-off cable and speed control rod. CTM42 (24MAR95) 115-36 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,115,36-19-16AUG94 160101 PN=419