Fuel System Operation and Test/Fuel Injection Nozzles—General Information FUEL INJECTION NOZZLES—GENERAL INFORMATION 115 46 RG5929 -UN-19AUG91 A—Fuel Inlet E—Intermediate Plate J—Valve N—Gland Nut B—Leak-Off Connection F—Nozzle Retaining Nut K—Spring Seat O—Fuel Passage C—O-Ring G—Washer L—Spring P—Edge-Type Filter D—Dowel Pin H—Nozzle M—Shims Q—Nozzle Holder Nippondenso Shown (Bosch Similar) The nozzle valve (J) is held on its seat by a spring (L). Shims (M) are used to regulate the nozzle opening pressure. An edge-type filter (P) is placed in the fuel inlet of the nozzle holder. Its purpose is to prevent coarse, foreign particles from damaging the nozzle assembly or plugging the orifices.
Finer particles pass through the filter without harm. The filter is not removable. The nozzle (H) and valve fit together by precision lapping. These parts are referred to as a nozzle assembly, and are not serviced separately. To provide a seal between the injection nozzle and the engine cylinder head, a steel washer (G) is used at the base of the nozzle retaining nut. Correct alignment of the nozzle assembly with its holder is essential so that the atomized fuel will be sprayed into the combustion chamber at the angle and location intended by design. KDEL and KDAL holders use an intermediate plate (E) with dowel pins (D) on both sides to insure alignment.
The fuel injection nozzle is fastened to the engine cylinder head by a gland nut (N). The gland nut also functions as a jack screw to raise the injection nozzle out of cylinder head during removal. A retaining nut (F) is used to fasten the nozzle assembly to the holder body. The diameter of the holder body is 21 mm, and from this dimension the fuel injection nozzles are known as 21 mm nozzles. RG,CTM42,115,22-19-28OCT92 CTM42 (24MAR95) 115-46 6076 Diesel Engines—S.N. (500000— ) 160101 PN=429