John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System Operation and Test/Fuel Drain Back Test Procedure CHANGE ENGINE RATED SPEED FROM 1800 RPM TO 1500 RPM AND ADJUST DROOP 1. Start engine and apply 50% load at rated speed until it reaches operating temperature. Remove cap nuts from adjusting screws before making adjustments. 2. When the engine has reached normal operating temperature, adjust fast idle (stop) screw (A) clockwise (CW) to 1500 rpm (50 Hz) with 100 % (full) load. 115 51 3. Remove load and back out the idle (bumper) spring screw (E), while observing the corresponding drop in engine rpm’s until engine quits losing speed. 4. Screw in idle (bumper) spring screw until engine speed increases 5—10 rpm. 5.

Check for specified no-load (frequency). If governor regulation is within 5—7% range, proceed to Step 8. RG5752 -UN-05AUG91 NOTE: A noticable click will occur at each 1/4 turn of droop adjusting screw. One click CW will increase no-load speed approximately 10 rpm, counter-clockwise (CCW) will reduce speed by 10 rpm. Maximum 24 clicks out, minimum 4 clicks out with final setting. A—Fast Idle (Stop) Screw 6. If governor regulation is above 7% or below 5%, stop B—Droop Adjusting Screw Access Plug Location engine and remove droop adjusting screw access plug C—Droop Adjusting Screw D—Slow Idle (Adjusting) Screw (B, shown removed) from top of governor housing.

E—Idle (Bumper) Spring F—Throttle Lever a. Back out slow idle (adjusting) screw (D) and and G—Mechanical Shutoff Lever bumper screw. Pull back on throttle lever (F, toward rear of governor housing) by hand until the droop adjusting screw (C) inside housing can be adjusted through the access plug hole. b. Screw the droop screw in (CW), counting the turns until screw bottoms out. Then, return screw to original setting. c. Screw in the droop screw (CW) no more than 1/2 turn (two clicks) at a time to reduce governor droop. CCW no more than two clicks at a time to increase governor droop (to reduce governor sensitivity). d. Replace access plug in top of governor housing.

Start engine, apply full (100%) load, and readjust high idle adjusting screw until 1500 rpm (50 Hz) is obtained at the specified power. e. Screw in idle (bumper) spring until engine speed increases 5—10 rpm. 7. Repeat Steps 6 (a—d) until governor regulation is within the 5—7% range. Replace all cap nuts onto adjusting screws and tighten lock nuts securely. CTM42 (24MAR95) 115-51 6076 Diesel Engines—S.N. (500000— ) RG,GENSET4,3 -19-11FEB93 160101 PN=434