John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System Operation and Test/Fuel Drain Back Test Procedure INSTRUCTIONS FOR CHANGING 6076 GEN SET ENGINE RATED SPEED FROM 1800 RPM (60 HZ) TO 1500 RPM (50 HZ)—MECHANICAL GOVERNOR 115 50 RG5753 -UN-05AUG91 A—Droop Adjusting Screw D—Throttle Lever F—Idle (Bumper) Spring H—Fast Idle (Stop) Screw B—Governor Housing E—Slow Idle (Adjusting) G—Mechanical Shutoff Lever C—Droop Adjusting Screw Screw Access Plug This instruction covers step-by-step adjustment procedures for changing 6076 Gen Set Engine rated speed from 1800 RPM (60 Hz) to 1500 RPM (50 Hz) while maintaining the desired speed regulation.

To assure specified governing, the fast idle screw and bumper spring screw (F) must be readjusted any time the droop screw (A) is adjusted. IMPORTANT: Only qualified technicians should attempt the adjustments covered in this instruction. If qualifications are in doubt, have your nearest ADS repair shop perform these adjustments. If an electric shutoff solenoid is connected to the shutoff lever (G) by rigid linkage, it must be adjusted to provide a gap of 0.0762 mm (0.003 in.), (one paper thickness) between the lever and stop. Too much gap will limit rack travel, no gap will bind the lever shaft. If flexible linkage is used, it should be adjusted for no gap.

To assure specified power and governing during engine operation, the throttle lever must be fixed against the fast idle (stop) screw (H). CTM42 (24MAR95) 115-50 6076 Diesel Engines—S.N. (500000— ) RG,GENSET4,1 -19-11FEB93 160101 PN=433