John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System Operation and Test/Fuel Drain Back Test Procedure TEST FUEL INJECTION NOZZLES (ENGINE RUNNING) 1. Operate engine at intermediate speed and no load. • If engine speed changes, the injection nozzle is probably working satisfactory. 2. Slowly loosen the fuel pressure line at one of the nozzles until fuel escapes at the connection (fuel not opening nozzle valve). • If engine speed does not change, a nozzle is faulty and must be checked and repaired (or replaced). NOTE: The injection nozzle before and/or after nozzle being checked could be the faulty nozzle. 3. Repeat test for each remaining nozzle assembly. 115 49 4. Remove faulty injection nozzles and repair as required.

See Group 35. S11,23010,HR -19-18APR94 FUEL DRAIN BACK TEST PROCEDURE N CAUTION: Maximum air pressure should be 100 kPa (1 bar) (15 psi) when performing this test. Fuel draining back through the fuel system may cause hard starting. This procedure will determine if air is entering the system at connections and allowing fuel to siphon back to the fuel tank. 5. Apply liquid soap and water solution to all joints and connections in the fuel system and inspect for leaks. 1. Disconnect fuel supply line and fuel return line at fuel tank. IMPORTANT: Fuel return line MUST extend below fuel level in fuel tank before performing this test. Fill fuel tank if necessary. NOTE:

Connections may allow air to enter the system without allowing fuel to leak out. 6. If any leaks are found, take necessary steps to repair. 2. Drain all fuel from the system, including the fuel transfer pump, fuel injection pump, fuel filters, and water separator (if equipped). 7. Reconnect supply and return lines and prime system. 3. Securely plug off the end of the fuel return pipe. 8. Start engine and run for approximately 10 minutes. 4. Using a low pressure air source, pressurize the fuel system at the fuel supply line. 9. Allow engine to sit overnight and try starting the following morning. CTM42 (24MAR95) 115-49 6076 Diesel Engines—S.N. (500000— ) S11,23010,JA -19-28OCT92 160101 PN=432