John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Head and Valves/Remove Cylinder Head REMOVE CYLINDER HEAD It is not necessary to remove engine from machine to service cylinder head on all applications. Refer to your Machine Technical Manual for engine removal procedure, if required. N CAUTION: After operating engine, allow exhaust system to cool before removal. TS281 -UN-23AUG88 RG5792 -UN-09AUG91 DO NOT drain coolant until the coolant is below operating temperature. Always loosen drain valve slowly to relieve any excess pressure. Remove rocker arm cover, if not previously done. 1. Drain all engine oil and coolant. Disconnect turbocharger oil inlet line at turbocharger or oil conditioning housing.

(See DISCONNECT TURBOCHARGER OIL INLET LINE in Group 03.) 05 10 2. Remove water manifold (A) and all coolant piping. (See Cooling System, Group 25.) 3. Remove turbocharger (B) and exhaust elbow (E). (See Air Intake and Exhaust System, Group 30.) 4. On 6076A Engines, remove aftercooler assembly (D). NOTE: Remove exhaust manifold before removing intake manifold on 6076HRW33, 34, and 35 engines. 5. Remove air intake manifold (C). (Group 30.) 6. Remove exhaust manifold. (Group 30.) A—Water Manifold B—Turbocharger C—Intake Manifold D—Aftercooler Assembly E—Exhaust Elbow RG,CTM42,G5,6 -19-17MAR95 CTM42 (24MAR95) 05-10 6076 Diesel Engines—S.N. (500000— ) 160101 PN=53