Cylinder Head and Valves/Check Valve Lift CHECK VALVE LIFT NOTE: Measuring valve lift can give an indication of wear on camshaft lobes and cam followers or bent push rods. IMPORTANT: For a more accurate measurement, it is recommended that valve lift be measured at 0.00 mm (in.) valve clearance and with engine cold. 1. Remove turbocharger oil inlet line clamp and rocker arm cover. Loosen locknut on rocker arm. Set valve clearance at 0.00 mm (in.). Tighten locknut. 2. Put dial indicator tip on valve rotator. Be sure that valve is fully closed. RG5789 -UN-09AUG91 3. Check pre-set on dial indicator. Set dial indicator pointer at zero. 05 9 4.
Manually turn engine in running direction, using the engine rotation tools previously mentioned for checking valve clearance. 5. Observe dial indicator reading as valve is moved to fully open position. VALVE LIFT SPECIFICATION AT 0.00 MM (IN.) CLEARANCE Intake . . . . . . . . . . . . . . . . . . 13.53—13.71 mm (0.533—0.540 in.) Wear Tolerance . . . . . . . . . . . . . . . . . . . . . 12.65 mm (0.498 in.) Exhaust . . . . . . . . . . . . . . . . . 14.52—14.70 mm (0.572—0.579 in.) Wear Tolerance . . . . . . . . . . . . . . . . . . . . . 13.64 mm (0.537 in.) 6. Adjust valve clearance to specification after measuring lift. (See CHECK AND ADJUST VALVE CLEARANCE, earlier in this group.) 7.
Repeat procedure on all remaining valves. RG,CTM42,G5,4 -19-14FEB95 CTM42 (24MAR95) 05-9 6076 Diesel Engines—S.N. (500000— ) 160101 PN=52