John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Head and Valves/Check and Adjust Valve Clearance 4. With engine lock-pinned at “TDC” of No. 1 piston’s compression stroke, check and adjust (as needed) valve clearance on Nos. 1, 3 and 5 exhaust valves and Nos. 1, 2 and 4 intake valves. VALVE CLEARANCE SPECIFICATIONS RG5241 -UN-06DEC88 RG4295 -19-21AUG91 Intake Valves . . . . . . . . . . . . . . . . 0.331-0.431 mm (0.013-0.017 in.) Exhaust Valves . . . . . . . . . . . . . . . 0.457-0.559 mm (0.018-0.022 in.) 5. If valve clearance needs to be adjusted, loosen the locknut on rocker arm adjusting screw. Turn adjusting screw until feeler gauge slips with a slight drag.

Hold the adjusting screw from turning with screwdriver and tighten locknut to 27 N·m (20 lb-ft). Recheck clearance again after tightening locknut. Readjust clearance as necessary. 6. Rotate flywheel 360˚ until No. 6 piston is at “TDC” of its compression stroke. Rocker arms for No. 6 piston should be loose. 05 8 7. Check and adjust (as needed) valve clearance to the same specifications on Nos. 2, 4 and 6 exhaust and Nos. 3, 5, and 6 intake valves. Tighten valve adjusting screw locknut to 27 N·m (20 lb-ft). 8. Recheck clearance on all valves again after locknut is tightened. S11,2005,NB -19-14FEB95 CTM42 (24MAR95) 05-8 6076 Diesel Engines—S.N. (500000— ) 160101 PN=51