John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Head and Valves/Check and Adjust Valve Clearance CHECK AND ADJUST VALVE CLEARANCE Too little valve clearance throws valves out of time. Valves open too early and close too late. This causes the valves to overheat due to hot combustion gases rushing past valves when out of time. Overheating lengthens valve stems which prevents proper seating of valves. The valves seat so briefly or poorly that normal heat transfer into the cooling system does not have time to take place, causing burned valves and low power. RG5790 -UN-09AUG91 Too much valve clearance causes a lag in valve timing causing engine valve train imbalance. The fuel-air mixture enters the cylinders late during intake stroke.

The exhaust valve closes early and prevents waste gases from being completely removed from cylinders. Also, the valves close with a great deal of impact, which may crack or break the valves and scuff the camshaft and followers. NOTE: Valve clearance should be checked with engine cold. 05 7 1. Remove rocker arm cover and ventilator hose (A). 2. Remove plastic plugs (B). IMPORTANT: Visually inspect contact surfaces of valve tips or wear caps and rocker arm wear pads. Check all parts for excessive wear, breakage, or cracks. Replace parts that show visible damage. RG,CTM42,G5,5 -19-03MAY93 3.

Rotate engine with the JDE81-1 or JDG820 Flywheel Turning Tool (A) until JDE81-4 Timing Pin (B) engages timing hole in flywheel. If the rocker arms for No. 1 cylinder are loose, the engine is at No. 1 “TDC-Compression.” If the rocker arms for No. 6 cylinder are loose, the engine is at No. 6 “TDC-Compression.” Rotate the engine one full revolution to No. 1 “TDC-Compression.” RG5791 -UN-09AUG91 CTM42 (24MAR95) 05-7 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G5,26 -19-14FEB95 160101 PN=50